BTS141BKSA1
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Through Hole |
| Package / Case | TO-220-3 |
| Number of Pins | 3 |
| Operating Temperature | -40°C~150°C TJ |
| Packaging | Tube |
| Published | 2014 |
| JESD-609 Code | e3 |
| Pbfree Code | no |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| Number of Terminations | 3 |
| ECCN Code | EAR99 |
| Terminal Finish | Tin (Sn) |
| Subcategory | Peripheral Drivers |
| Voltage - Rated DC | 60V |
| Max Power Dissipation | 149W |
| Technology | MOS |
| Terminal Position | SINGLE |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Number of Functions | 1 |
| Supply Voltage | 12V |
| Terminal Pitch | 2.54mm |
| Reach Compliance Code | not_compliant |
| Current Rating | 25A |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Number of Outputs | 1 |
| Qualification Status | Not Qualified |
| Output Voltage | 60V |
| Output Type | N-Channel |
| Interface | On/Off |
| Output Configuration | Low Side |
| Power Dissipation | 149W |
| Voltage - Supply (Vcc/Vdd) | Not Required |
| Switch Type | General Purpose |
| Drain to Source Voltage (Vdss) | 60V |
| Nominal Input Voltage | 60V |
| Continuous Drain Current (ID) | 12A |
| Ratio - Input:Output | 1:1 |
| Voltage - Load | 60V Max |
| Max Dual Supply Voltage | 60V |
| Driver Number of Bits | 1 |
| Fault Protection | Current Limiting (Fixed), Over Temperature, Over Voltage |
| Output Peak Current Limit-Nom | 12A |
| Rds On (Typ) | 25m Ω |
| Drain to Source Resistance | 28mOhm |
| Built-in Protections | OVER CURRENT; OVER VOLTAGE; THERMAL |
| Output Current Flow Direction | SINK |
| RoHS Status | ROHS3 Compliant |
BTS141BKSA1 Overview
As a result, it is packaged in the form of a Tube.It's included in the TO-220-3 package.Through Hole is the mounting type of the LED driver.General Purpose is the switch type it owns.In order to guarantee reliable performance, the temperature should be set to -40°C~150°C TJ.As a default, the output is set to 1.The LED driving board is powered by a voltage of Not Required.The maximum output voltage of this LED driver is N-Channel volts.It contains 3 terminations.The operation is carried out using the 3 pins.As far as the lighting driver is concerned, there are 1 functions.High efficiency is possible when the supply voltage is set to 12V.The lighting driver is mounted in the direction of Surface Mount.Self-contained in an econtainer with a capacity of Peripheral Drivers, this LED driver is self-contained.
BTS141BKSA1 Features
Supplied from 12V
BTS141BKSA1 Applications
There are a lot of Infineon Technologies BTS141BKSA1 Power Switches ICs applications.
- USB Power Distribution
- Low Voltage I/O System Power
- Notebook PC
- USB Ports/Hubs
- Wearable Devices
- Wireless Modem Data Cards
- Various applications equipped with buttons
- PC Cards
- Storage Drives
- Portable GPS
